-
Numbers
Check this out I went to Turbo Technologies and tune my car today. I have YS Trim setup and put down 710 rear wheel horsepower and 681 rear wheel torque. Now that was a sh.ot heard around the Turbo community here. A supercharged car at a turbo headquarters. Now tell me I don't have balls. I will say this George Scott can tune anything on wheels. Dr. Dave Bliss can build anything with Balls. I want to gave special thanks to Dave Bliss for building the engine and giving me knowlege.
"Dave you are the man" You guys in the Northwest this man is a ICON you don't want ti miss.
COME CORRECT OUT !!!!
You caught me :D
-
-
Awesome numbers. What's your combo?
-
Sweet! How much boost/timing did you run? What pullies did you use and how high did you rev it?
-
Well Peezoes,
It goes something like this:
A whole lot of MONEY and few sacrafices....
20 degrees of timing with 16 pounds of boost.
Add a 3.400 stroke to a R-302 block and then talk to Andrew about the cam. Call John91coupe for verification on the stick. Email a guy name Cope; Watch and read what John and Andrew have done evaluate there results.
Define the prognosis:
Have Dave Bliss at Bliss performance as your engine builder.
Have Frank and Brent on the phone for support.
Talk to JR and Lenny at Dynamic Racing; Listen to Stephen Lee and Mike Post.
If you dont Know ask George Scott (Turbo Technologies) about the tune.
Then the most important is give everybody there PROPS, and tell them THANKS.....
-
Hmmm