-
sn2000 is no joke!!!!
88 mustang, fresh 306 shortblock with hyper pistons, edelbrock heads and intake,70mm t body,e cam,1.6 rockers,42lb injectors,255 intank,75mm pmas, anderson power pipe,2.5 flowmasters, centerforce,t5,msd, snow watermeth.26 total w spout in. she made 434hp 423 torque on a mustang dyno at 8lbs boost running 12.4 air fuel. The car spins the tires under full boost in 2nd gear at 75mph haha!! it has 2.73 gears. I could not be more happy with the numbers and it is a total sleeper the blower makes no noise at all.
-
Can you scan and post the dyno sheet(graph).
I would like to see the torque curve.
-
Ya, i will try to get that up this weekend, my scanner is broke so have to use a freinds.
-
wheres the graph? good #'s
-
I am going to my brothers tomarrow and will get them up then.
-
And if i told you what the inch pound reading is when you push down on the blower pulley you would not believe me. I talked with speedy about this and he has never seen one run with this much. Its 90-95 inchpounds. and the blower came that way from paxton.
-
That's insane much torque, this wil cost you hp and maybe beltslip aswell
-
90-95inlbs wet torque. I don't see the unit lasting as a daily driver. Just to much friction.
-
how do you measure said torque? Just curious?
-
On the pulley bolt with the belt of with a torque wrench, rather not a clicking wrench.
Just see howmuch torque is needed to turn the pulley.
With or without oil or completely dry.
-
alrighty I thought you were measuring some other way..That is crazy amount..
-
-
I have not had time to use my brothers scanner, so i just snapped a pic with my cell phone haha i will get a good pic up this weekend. you can see that it is up over 420 horse on this sheet it was 434hp and 411 torque. on one of the pulls it made 423 torque. Its hard to read but i did not want to look like i was bs.HAHA
-
-
1 Attachment(s)
Y is it so small?haha. oh well you just need very good eyes.