wHAT `DO YO GUYS FIND IS THE BEST WAY TO CUT OUT THE FENDER AREA TO INSTALL A POWERPIPE
Printable View
wHAT `DO YO GUYS FIND IS THE BEST WAY TO CUT OUT THE FENDER AREA TO INSTALL A POWERPIPE
David, I used a jigsaw with a metal cutting blade. Just removed the base off it, worked like a charm.
I just used metal sheers! Than I outlined it with a door gasket to make it look neat!
I used right and left handed tin snips, worked perfect.
I used a dremel tool with a cut off wheel on it. It took all of 10 minutes of cutting to get the job done. Too bad I don't have a blower on it anymore, now all I have is a big hole :(
I'd think the dremel would do the neatest job.
Die Grinder with a cutting wheel works well. Makes a good clean cut too.
I used a cutting wheel on the air compressor. they are like 25-30.00 if you have air.
Air powered cutting wheel,,, after I cut some vac. tubing to cover up the rough edge and protect the PP.... Lee
tin snips