Printable View
For those of you that switched to an 8-rib conversion on your 99-up Mustangs, where did you get the 8-rib idler pulley that mounts on the ATI bracket right under the S/C drive pulley. I called ATI, and they said that they don't make them, and the guy wasn't sure where to get it from.
Thanks,
Eric
Eric,
I think I have talked with you over e-mail? I am just restoring my e-mail after a crash so I will get back to you.
Ian
Ian,
Yep, I did send you an e-mail. I was wondering why I hadn't heard back yet. If I were to send you the stock pulley (6-rib) to look at, could you and how long would it take to get an 8-rib from you?
Thanks,
Eric
IAN.......YOU ABSOLUTELY RULE!!!!
Got the pulley today, and it is 110% perfect!! It is the exact same dimensions as the stock ATI 6-rib p.o.s. pulley (vice being 8 rib). All I can say is wow!! I appreciate it.
Eric
P.S.- If you haven't already, you might want to hold onto those specs for anyone else going to the 8-rib ATI setup for their Mustang. Again, the specs are perfect!
You are more than welcome Eric! It is a very trick looking piece.
Please take some pics so all can see :)
Ian
Here ya go....(mind you, Ian made this with only a couple of dimensions that I sent him, never having seen the original pulley!)
Hmmmm..... the pics didn't show.
Are you using the attach feature?
If that is not working use the photopost and upload.
Ian
Photos are now in photopost...
Here you go:
http://www.superchargerhelp.com/phot...23sch6-med.JPG
http://www.superchargerhelp.com/phot...23sch3-med.JPG
http://www.superchargerhelp.com/phot...23sch5-med.JPG
Nice looking pulley :)
Ian