Printable View
I am thinking of going with the new ebock head, I have a tfs street heat intake I am not sure which ebock head I will go with 2.02 or the 1.90 intake, not sure if they are both smog legal. Which leads me to the other ? are both the tfs 1 and 2 cam smog legal? I think I saw that Ian passed emissions, but cant remember if that was with the 1 or 2 cam. I will be running 8.5:1 compression on the new block, and will have notched pistons, so I dont think clearance will be a problem
Thanks, Greg
Hi Greg,
I passed my e-test with no EGR, PCV, ect.. I did have the air pump pumping air to the high flow cats, and I was using the Trick Flow Stage 2 cam..
Ian
thanks Ian, I am going with edel new 1.90 head, tfs stage 2 cam, did you use stock length push rods, I will be using hardened rods?
Thanks, again
Greg
Hey Greg,
I used 6.390 pushrods (I actually still have them, and for sale) You will need to use a 1 piece hardened pushrod - I like Comp and Crane.
Ian
so the ford motorsport rods would be too small? with edelbrock heads? I had a buddy with a 95 cobra, he went with edelbrock heads, crane 2031 cam, the rods were too small, crane said the base circle of the cam is smaller then others, is this true with tfs cams, also looking at the crower cams
I cannot say 100% in your case, but with my AFR 165's, comp cams 1.6 magnums and the stage 2 cam I needed 6.390. You will have to get the tool and measure them out to make 100% sure.
Ian