Dyno Results On A Stock 5.0 Stang
Ok, here are the initial numbers on my mustang 5.0 project:
ENGINE: STOCK 5.0 only 1.6 rockers added ( the engine has 100,000 miles on it)
HEADERS; BBK equal length into 2 1/2 exhaust, no cats, 2 flowmasters
INTAKE: TYPHOON from performance specialties
THROTTLE BODY: 76 mm. and EGR spacer
FUEL: Inline 255 lph, 24 pounds injectors, adjustable fuel pressure regulator
PROCHARGER FMU ( yes I know what are you thinking guys...but this setup is working wonderful...)
C&L 76 mm airflow meter calibrated to 24# injectors.
MSD6AL and blaster II coil
A9L stock computer...NO CHIP
P600B and 2 core intercooler
OK here are the numbers t the wheels:
PEAK HP: 341.6 AT 6,000 RPM
PEAK TORQUE; 379.70
I will get the DYNO page scanned tomorrow and post it as soon as possible.
By the way, I still have the smog pump on, also the fan clutch and fan, and also all tests done with normal gas pump...I think below 89 octane rate.
I still need to do a little adjustments and improvements, but I am sure I will reach 390 hp and 420 torque with a few adjustments.
So please guys send me all your comments and suggestions.
Pablo