Warning: preg_replace(): The /e modifier is deprecated, use preg_replace_callback instead in ..../includes/class_bbcode.php on line 2962 Home made power pipe.
I thought I would share some pics of the powerpipe I made a couple months ago.
I worked on deciding how to make it and what to make it out of for a while. I made a couple different ones and this is the one I ended up with.
It's made out of two rubber 4", 90* angles. One plastic 4", 90* angle, a straight peice of 4" plastic pipe (for some extra length), a coupler to attach the straight the piece (the same type of coupler material to attach your discharge tube on each end- only 4" diameter) and a plastic reducer from 4" to 3".
It cost me around $50 canadian for all the materials.
The results of it:
I went from 8lbs to 10lbs of boost. I went from a 114.7mph to 119.0mph.
Cool deal, I thought about doing something similiar but Ian cut me a good deal on a used Morpheus pipe. I imagine that the plastic construction is a bit better to avoid heatsoak vs. a meatal one. 2#'s for 50 canadian ain't shabby at all.
09-24-2003, 02:29 AM
RydeOn
sounds great!! Did you cut the fender to do all this, or did you just leave it?
09-24-2003, 12:43 PM
sinner
No, I had to cut the fender to squeeze the 4" tube through it.
If your worried about the fender, you could probably rig it up to reduce to 3" just before and it would fit through