A few combo questions

Have a few questions about my injector sizing.

327 c.i.d. sportsman block
x-303 cam
AFR 185's
1.6 rockers
Holley systemax intake
Accufab 75mm
83 mm pro-m
42lbs injectors
Anderson PMS
Aeromotive comp kit w/sumped tank
TKO
Paxton Novi-2000 w/Anderson powerpipe
I would like to see 570 or higher at the rear wheels but I think my injectors are smallish..need 50's or 55's correct? Also the novi has the stock pulley on it,what size pulley do you guys reccomend? This is a street car so pump gas is a issue
tonyalester@earthlink.net

570+ RWHP is pushing the Sportsman block IMO. You might want to think about a stronger block (A4, R302, Dart). What internals are you going to run?

you may be suprised with what the stock pulley will net you. dyno it with the stock pulley and at least you'd have a starting point where pump gas won't be an issue.

Quote:

---

Originally Posted by Whistler

570+ RWHP is pushing the Sportsman block IMO. You might want to think about a stronger block (A4, R302, Dart). What internals are you going to run?

---

Not too worried about the block my previous motor by DSS was a stock block 302 w/ no girdle that surrvived until I pulled it out and sold it at approx
30,000 miles making 492 hp at the rear wheels. The only thing I replaced before selling it was the rod and main bearings. The new motor has all eagle forged crank and rods w/J&E pistons.

i'd think it'd be just fine. and you know what? it will or won't, that's my motto. be alil conservative @ first and it'll be fine. It'll be screaming with stock pullies anyway.