John,
Is your friend car clogged?
You both have super clean cars!
MIKE
Printable View
John,
Is your friend car clogged?
You both have super clean cars!
MIKE
it sits low as well ,check it out compared to the nissan next to it
Oh and decal are gone now ,stupid company dropped my car off their hoist ,grrrr
Who does the fantastic body work for you?
1bad86Gt,
What size tire under there?
MIKE
Mike,
No, his is 12 rib also. Do you see a pattern? His runs 9.2s' @ 148.
at the track ffor that that 1 run on 7 cylinder ,doh,lol
bad pic -taken at nite
John,
It has me wondering.
The bodywork is done by a couple of friends and paint by another friend at his shop near where I live ,it's called Rich City Collision in Richmond,BC ,Canada .
The tires are 31x 14.5 ET streets on 15x 12 wheels w/ 3.5 bs.These are actually small on the car but they are the largest allowed up here in it;s class,I can fit at least 18 inches of tire and a 32 maybe a 33 but it would be really close
I may need to re-think my current plan on going to cogs on this blower. I ran my P1200 with cogs
and had no problems. This D-2 could be another story though, even with it's huge bearings.
Yeah I though about the same thing,cogs......
Maybe I should go with a 12 rib setup.
1bad86gt,
What cog ratio you run?
I have a 66 crank and I think it's either 44 or 46 or was it a 42 ,lol on the blower I don't remember , works out to around 53000 @ 8250 .I shift at 8000-8200
Can't get to the car right now
John,
What size elbow you have connected to your TB? Thanks!
Maybe this is why ATI doesn't offer any guarantee with their cog setup.
you guys ,I go by mcqwik on the other sites and my name is john as well