Just had the car dyno'ed....

I'm goin to be gettin my car dyno tuned too since I just put in the new motor and what not, but I was wondering 5150 LX if you could tell me what combo you had when you got that dynoed? it was the 302 with the ATI right? what else did you have as far as mods? did u have those heads and intake? I have pretty much the same setup and I want to know what to expect. Thanks.

K.C., never have dynoed mine. I was running stock shortblock, TFS heads and Novi 1000. You may have me confused with someone.....

Quote:

---

Originally Posted by 5150 LX

K.C., never have dynoed mine. I was running stock shortblock, TFS heads and Novi 1000. You may have me confused with someone.....

---

ohh yea.. oops.. my bad, I meant StangQuest..

Quote:

---

Originally Posted by 5150 LX

Ouch, what did you hit?? or what hit you??

---

I hit a Tahoe:( I didn't react fast enough when the lady in front of me slammed on her brakes during morning rush hour......oh well lesson learned.

Tomorrow she goes away:( I traded the roller for a NIB TKO and BH. Here's a pic of the damage which is definately repairable and a pic of the car that will be receiving all the good stuff off the damaged car.

http://www.mustangmods.com/data/560/rmh_026.jpg

http://www.mustangmods.com/data/560/rmh_019.jpg

Damn, I remember seeing that pic.....

Quote:

---

Originally Posted by K.C.90gt

I'm goin to be gettin my car dyno tuned too since I just put in the new motor and what not, but I was wondering 5150 LX if you could tell me what combo you had when you got that dynoed? it was the 302 with the ATI right? what else did you have as far as mods? did u have those heads and intake? I have pretty much the same setup and I want to know what to expect. Thanks.

---

Those numbers were with a stock rotating assembly, crane 2030 cam, box stock Performer Heads, RPM Intake, 75mm Pro M caled for 24 pounders, Pro M Optimizer to tune the MAF for 36lb injectors, FMS 36lb injectors, MSD 6AL, MAC headers, MAC O/R H-pipe, 2 chamber flows with stock tail pipes, P600B pullied for 14psi but I've never seen more than 10psi, and a 3 core IC.

I never got any numbers with my UNIVER, 42lb injectors, and TwEECer.

Quote:

---

Originally Posted by blown sn-95

i see your running a univer.. i am not sure if i am going to run a univer or bullet? i have pretty much the same set up. do you have any probems with the blow through?
did you have to have it tuned?

---

No I didn't have any issues with the UNIVER at all. I had a TwEECer to tune whatever I needed to.