Here is a pic of the setup that Ian and I have plus quite a few others. This is a mandatory upgrade for the Novi on a fox. The plastic one will not last more than a month before it collapses on itself. Plus it is easier to install the Bosch bypass with this set up.
Let me know if there is any further interest in these tubes because I may be able to help those who don't want to screw with making one themselves.:)
http://www.imagestation.com/picture/...b.jpg.orig.jpg
I can't see the picture--it says "Sorry...you are trying to access an image from outside of ImageStation.com"
OOPS--Now I see it--didn't show up the first time, though.
Forrest
i would definately be interested in one for mine. the plastic junk is already caving in on mine. are you going to get them made up and then sell them? if so how much?
Here is an engine shot of my car, I use the 468LC blower inlet.
http://www.stangpower.com/photopost/.../1fan2-med.jpg
Ian
That's a nice-looking pipe--nice smooth curve! I would think that a lot of people would be interested in getting one.
I made my own, because I had to reclock the blower to clear the hood in my Cobra, so the pipe had to be somewhat longer than stock. I have a bandsaw and TIG welder, which made it possible, but most folks do not.
Forrest
Your cobra ownz forrest1!
:D
I'd like to take a stab at rolling my own -
Is this built from a 3" OD mandrel bent 90 L? Was thinking maybe a SST tube from Magnaflow would be nice, but I'll probably be DIY ceramic coating the pipe with Techline, like my headers. Looking at Magnaflow's website, I'm not sure if their short pipe bends are SST or not; they are listing a 3" 90 L with 14" length to the bend and a 5" radius in the C-line (part #10709). Is this about what is needed? thx
I'd be interested in a custom discharge tube!! This POS plastic junk isn't going to cut it for much longer...
I haven't installed my Novi 1K yet but what you guys are saying about the factory discharge I don't even want to install my kit without a custom one or a aftermarket one. So I would be interested in one if you are going to be producing some.
Send 468LC a PM and see if he can hook you up :)
Ian
My most recent pipe I made for myself.
Turned out pretty good and is polished.
It's not perfect because anytime you mandrel bend tubing it gets pretty scratched up.
http://www.novipower.com/photopost/d...hedjpg-med.jpg
Steve,
I'm interested in your blower inlet pipe. How much can you hook me up for.
Thanks
Troy
Steve,
Please let me know how to get one of these from you. Do you also have a steel inlet tube?
Troy
Troy you must not have got my e mail from several weeks ago.:oQuote:
Originally posted by ISLANDLX
Steve,
Please let me know how to get one of these from you. Do you also have a steel inlet tube?
Troy
I can set you up no problem.
E mail me at SBeasley@Prodigy.net
My inlet tube is a basterdized setup to move the filter into the fender. It consists of the stock plastic paxton inlet, the 45* part of the stock inlet, a 3" piece of tubing and the MAF with the filter on the end of it.