Im running the D1SC 12 rib setup Im getting about 8PSI right now with the 4.25 inch blower pulley.I take the motor up to about 6300 right now.This is on a 408W.What size pulley should I run to get say 15PSI.Thanks again.
Im running the D1SC 12 rib setup Im getting about 8PSI right now with the 4.25 inch blower pulley.I take the motor up to about 6300 right now.This is on a 408W.What size pulley should I run to get say 15PSI.Thanks again.
Originally posted by spec
Im running the D1SC 12 rib setup Im getting about 8PSI right now with the 4.25 inch blower pulley.I take the motor up to about 6300 right now.This is on a 408W.What size pulley should I run to get say 15PSI.Thanks again.
Well this is a completely different setup than you have, but the same blower. 302, stock short block, stock cobra intake, D1SC 6-rib setup, Gt40X heads cleaned up, .529 lift E303 cam, full exhaust...blah blah.. On a 3.85" pulley the car made 10psi, and on the 3.55 the car is at 13 @6000 rpm.
I'd call ATI to verify, however I would guess to say that anthing from a 3.55 to a 3.30 should be the right size revving your motor to 6300.
Dan
1995 Rio Red Cobra #2021
Dart 331,AFR185,D1SC,RPMII upper/lower
OLD
GT40X, E303, D1SC 13psi, 3 core intercooler, Magnaflow Catback, Hooker equal lengths, Mac Prochamber, 3.73, Auburn, Moser 31 splines, Pro-m75, MSD 6AL, TKO, Spec Stage III, Larocca Tuned
10psi 11:1 a/f= 464rwhp 431ft/lbs
11.9@123mph @13psi 1.9 60'
hp? tq?
Moderator of General Tech
Bookmarks