can i run my new novi 2K this way?

[bdhollie]

can i run the 36lb injectors,255 in tank and trex with the novi 2K in stock form with no fmu and no powerpipe and still be okay? I am getting my jms chip reburned for the new combo so it should be properly tuned, i realize if i add a powerpipe i would probably have to go up to 42`s or more but I already have the 36`s and meter so i am stuck for now.
I am almost sure it would be fine as long as i leave it in stock form, but i want some other opinions. thanks guys, Bryan

here is my current combo:

`90 LX Hatch
Keith Craft 306
TFS Track Heat Heads -unported
TFS Track heat Intake -unported
75mm Pro-M
70mm Accufab TB
30lb. injectors over injected, need 24`s
Anderson B-3 Cam
3.73
26X10 ETStreets
Draglites
4-point cage
Sub Frames
Lakewood 70/30 struts
Lakewood Drag Springs
Comp. Eng. Rear Shocks
Tremec 3550 w/ Hurst
155lph in-tank
T-Rex external
JMS Chip
*Blower coming soon!

[TheHawk05]

You'll be Ok. Doug ran his coupe that way fuel system wise and his mods are similiar. He made 470+ to the wheels and was OK Air/Fuel wise.

[Doug]

Yep that was my car with the old combo. Here a pic of the dyno sheet, notice the A/F readings at the bottom of the pags. It ran great until I tried to add a bit of NOS to it.

[bdhollie]

hey doug, did you run the stock intake or did you have a powerpipe too? i would like to run one if i could get away with it. and you didnt have an fmu? did you have a chip or just a good tune? thanks Bryan

[bdhollie]

and by the way, what was your old combo?

[Doug]

Originally posted by bdhollie
and by the way, what was your old combo?

Novi 2K-stock pulleys
Power pipe
AFR 165's
1.7 rockers
stock cam
TFS track heat intake 70mm t-body
36 pound injectors
Pro M 80
No FMU
dyno tuned with a chip
pretty simple combo, but it ran good. The best pass was 10.82@126
Doug

[bdhollie]

that combo is VERY similar to mine, what did you make on the motor? I am at 325hp,350ftlbs at the wheels with this motor, and what were your dyno #`s with the blower? thanks again for the help. Bryan

[ssj50driver]

talked to my buddy with a smilar setup on an 87 gt.. he said it is a ok and i second it.. so 2 opinions in one post! ;) can't beat that... goodluck

[Doug]

Originally posted by bdhollie
that combo is VERY similar to mine, what did you make on the motor? I am at 325hp,350ftlbs at the wheels with this motor, and what were your dyno #`s with the blower? thanks again for the help. Bryan

Bryan,
I never ran it on the motor. I installed the bower on the stock motor and a little while later I installed the heads, intake, t-body, MAF, and injectors.