Need a pulley?

[root]

Please let me know what you need. We have many styles and sizes in stock. We can make just about any pulley in any size!

Ian

[11lb]

I need one for the procharger P600B 8 rib but it has to be 3in. its the tension pullie. how much?

[Hotrodvdog]

What size pulley would you suggest for an ATI P1sc in order to run 14lbs-16lbs of boost? I currently have the 10lb pulley supplied by ATI and was also wondering if it's a 8 rib pulley? Do you make one that would replace the ATI pulley in the same configuration. Would I need a smaller belt? thanks :)

[HazMat]

Hey Ian, how about 50mm cog pulleys?

[Hotrodvdog]

Ok, I'm ready to buy and I would like a 3" pulley for the P1sc that would replace the 10lb pulley I have now. Let me know so that I can purchase it. thanks

[HHStang]

I need ribbed crank pulley to fit 460 Ford for Procharger D-1. I also wondered if you know of a bracket that mounts this unit and what blower pulley sizes and prices are. Thanks, Mike

[root]

Hotrodvdog: I got your order, and will get working on it this week.

HHStang: At this time, I do not make crank pulleys, nor do I have brackets for the 460's.

Thanks,

[RNMHARD]

I JUST BOUGHT A 90 COUPE WITH A CARBED 351W WITH NEW D1SC PROCHARGER KIT , CAME WITH THE 15LBS PULLEY. I WANT TO BRING BOOST DOWN TO ABOUT 10LBS.

WHAT SIZE ? HOW MUCH ?

THANKS , TIM

[camarossguy2]

Please let me know what you need. We have many styles and sizes in stock. We can make just about any pulley in any size!

Ian

I need a 12 rib setup for my LT1 P1SC kit and a tensioner if i need that(i have the 8 rib, dont know if its wide enough)

looking for a 2.439 ratio pullys (times 4.10 step up x 6000 RPM = 60,000 blower RPM)

Please give a price for the entire 12 rib set up

AND

Price for just a 3.10'' to 3.20'' 8 rib pully if you can make that.


THANX

[FoMoCo1]

have any 10 rib pulleys for the N2K yet?

[bobtodd]

How about a 6lb pulley for a Powerdyne?? What would that cost? Thanks!

[Gibson17]

Looking for 10-12psi out of my P1SC, right now i have a 4.25" pulley on my 347 saleen, what size would i need? i was thinking it would be around 3", let me know what size i need and how much it would be. i have cash waiting!!

Keith

[underpsi68]

I'm looking for a 3.50" 8 rib Vortech blower pulley for an S trim on a 90 Mustang. Do you have anything like this or can you make it?

Thanks John

[Gibson17]

i talked to procharger and they tell me i need a 3.55" pulley, so let me know how much a 8 rib 3.55" pulley for a p1sc would be. Thanks email me at gibson_lp_ks@hotmail.com

Keith
90 saleen

[fanglemeister]

Have any of the Novi 1000 single belt guys requested a complete 8-rib conversion setup yet? I realize the a/c is probably a goner, but seems the H2O, alt, and crank pullies would be doable.