What size cog belt? Thanks :)

[slowfive0]

I have a Novi 2000 (passenger side mount) with a cog setup. I need to know which belt I need, where to get it & an @ price if you know. This is for an 8.2 deck motor. Thanks guys :D

The cog sizes are:

Crank 78 tooth
Blower 35 tooth

[slowfive0]

Wow, what was I thinking. Expecting that a site for Novi 2000's might have someone on board that knew this belt number.... :( Thanks anyways....

I have a Novi 2000 (passenger side mount) with a cog setup. I need to know which belt I need, where to get it & an @ price if you know. This is for an 8.2 deck motor. Thanks guys :D

The cog sizes are:

Crank 78 tooth
Blower 35 tooth

[Hustler]

Lol no need to get pissy. I've been gone for a few days, I haven't seen that pulley combination before. I run a 73/33 personally. There are a few cog belt users here but I've only seen 77 crank pulleys. It's not as easy to guess either. I had ASP guess at the belt I was going to need, it turned out to be a tad short, no biggy just sent it back and now I'm using a 1440 8M pitch

I'm using a single tensioner on my passenger mount so it may be different.

73/33 - 1440mm 8M pitch HT - Gates Powergrip GT 2
73/32 - 1424mm 8M pitch HT - Bando Synchro-Link
73/30 - 1392mm 8M pitch HT - Gates

You need to get a string and run it around the pulleys, that will get you a close number as to what you need as far as length.

http://www.bandoamerican.com/products_home.htm
http://www.gates.com/sync/index.cfm?fit=yes

[slowfive0]

Sorry to get pissy :) I had a crappy day and it isn't too often that I post and when I have (at least the last two times---not here though), I didn't even get one reply. No novels or stupid questions either, so I guess I was venting a little. Sorry about that

Thanks for the reply. Very good info to start with. Take care...