pulley mounting?

[RedGTZ]

Hi guys,

I've bought a SN-92 for a custom application and i need a special interchangeable pully that i will machine. Since my SN has no pulley on it i was wondering how does the pully was secured there. Is the a only bolt at the front of the shaft that hold it there? Is it a press fitted pully? Is it holded there by the keyway and set screws? Hows the fitting on the shaft?

Any of you guys have a good photo of it?

Thanks for any help!

[speedytang]

Keyway and it is very snug and uses the 1 bolt to attach.

[RedGTZ]

Keyway and it is very snug and uses the 1 bolt to attach.

The bolt you are talking about screw at the end of the shaft or is it a bolt that screw over the keyway on the pullyto secure both keyway and pully?

thanks!