TUBES OR NOT

[383STROKER]

I just got a new set of 10x15 draglites with a 6.5 offset for the stang. I have a used set of 28x10.5 MT ET drags that came with tubes. Should I use the tubes or not? a lot of people are telling me theres no need. What do you guys think?

[mechfan81]

i would personally, just an extra step of protection there.

[Fast]

If your not going to put screws in your rims do not use tubes,it will cause the tire to spin on the rim and cut the valve stem on the tube

[BLOWNBY]

The tubes will make the sidewall a little stiffer and more stable down the track. I ran my 26x 10 ET DRAGs with tubes and no screws and never had any issues. 1.4x 60's. I also ran the 27" Hoosier QTP with tubes and had no issues.

The ADV of tubes: is consitent air pressure and more stable top end.

DIS -A little more rotating mass(minimal effect) and if not screwed and spin will likley rip out the valve stem.

You'll have to weight what makes sense for you.

[blownzoom440]

BLOWNBY has a lot of good points.i use tubes and just prefer the secyrity that the air will stay in and there is less maintenance,upkeep with psi by using tubes.

[93gt]

Should screws be used with the tubes then?

[Fast]

well,I would say screw them and just be on the safe side if you want to use tubes

[BLOWNBY]

Should screws be used with the tubes then?

Probably, but I was cutting 1.4x 60's for two summers on slicks with tubes and no screws. Probably should have but never had an issue. I really didn't want the screws in my rims so never messed with it. I also ran 11.5 psi.