FS 87-93 Vortech T-trim w/renagade setup

[Sick88lx]

For Sale:

This kit has less than a 1k miles on it and was on a mainly track only car with very little street miles. It has never been cogged even though it has Heavy Duty bearings from the factory. It is for 87-93 Mustangs and the car it came off was setup for blowthrough carb. The only modification you would need to make it work on a EFI setup is a plastic tube from the Mondo BOV discharge to vent back into the power pipe. Probably cost $5 from Home Depot. IF you have a DFI system you dont have to do that you can let the BOV vent to the atmosphere.

Comes with everything you see here:
-Vortech T-trim
-Brackets
-3.15/8" Renegade pulley setup w/belt
-Mondo BOV
-Aluminum Discharge Tube
-Aluminum Home made power pipe
-93 Cobra Water Pump Pulley to clear crank pulley
-Billit Smog Pump Eliminator
-HTS silicon hoses
-oil sending unit
-Nuts, bolts, washers etc...
-K&N air cleaner
-t-bolt clamps
-chrome water neck
-instructions

$2200

[todthebod]

For Sale:

This kit has less than a 1k miles on it and was on a mainly track only car with very little street miles. It has never been cogged even though it has Heavy Duty bearings from the factory. It is for 87-93 Mustangs and the car it came off was setup for blowthrough carb. The only modification you would need to make it work on a EFI setup is a plastic tube from the Mondo BOV discharge to vent back into the power pipe. Probably cost $5 from Home Depot. IF you have a DFI system you dont have to do that you can let the BOV vent to the atmosphere.

Comes with everything you see here:
-Vortech T-trim
-Brackets
-3.15/8" Renegade pulley setup w/belt
-Mondo BOV
-Aluminum Discharge Tube
-Aluminum Home made power pipe
-93 Cobra Water Pump Pulley to clear crank pulley
-Billit Smog Pump Eliminator
-HTS silicon hoses
-oil sending unit
-Nuts, bolts, washers etc...
-K&N air cleaner
-t-bolt clamps
-chrome water neck
-instructions

$2200

I know this is 6 months late but just checking to see if you still had and wanted to sell.