Well I got the 1985 Mustang running using a PMS from Anderson Ford. She runs decent but I can tell she needs to be tuned to get some small glitches out of her. What I cant believe is the heat that comes off this motor in such a short time. I expected heat but after 2 to 3 min of idle time I cant touch my inlet pipe from my supercharger to the throttle body its to hot. I dont run an intercooler yet but I think I soon will. My temp gauge is good and the temp on my PMS is in the 160 range in that 3 min period but she never overheats when I street drive her. She does get to 200 if stop and go traffic but if im moving she is fine.. Its a 331 with 9.25 compresion and is now fuel injected obviously. My T-trim is pullied for about 20 lbs of boost, I have a 77 tooth crank and I think my blower is a 30 tooth but I cant remember. I use c-16 vp fuel with an Anderson B-4 cam, the fuel system is all aeromotive from front to back with a 1000 pump and 72 lb low imp injectors with the Anderson inj drive module. I just wondering is this normal or can I poss be that lean. I havent reved the car past 4000 yet trying to put a few miles on it and make sure everything is tight with no leaks. Thanks for any info.
Bookmarks