Mondo bypass

[todthebod]

I was mocking up my discharge tube with mondo bypass and it looks like the mondo will be a tight fit between the valve cover and shock tower. I mean a really tight fit, like I'll have to put a bar from the frame to the motor to keep it from torquing over. I guess I could fab up something like AFM makes and relocate the bypass. I might could get an intake spacer to raise it up a little but then I don't have much room between the hood and my intake as it is (351w). Any one else have this problem?:straight:

[BLOWNBY]

It's tight but fits. with enough room to be OK>>>


Not sure if this helps???
http://www.superchargerhelp.com/atta...achmentid=1224

[hemann]

Two questions about the pic.

Where did you get the spacer between the intake and throttle body?

What brand of power pipe are you using?

[BLOWNBY]

AFM power pipe!
I beleiev it's just an EGR spacer form Holcomb Motorsports.

[BLOWNBY]

Also It is designed to mate with my accufab TB As well I beleive!

[hemann]

Thanks for the info.

I have an Anderson pipe ordered. I have a Morpheous right now that will not work. Worked OK for my S-trim with the rubber elbow but not for the aluminum elbow.