-
Junior SCH Member
Loctite for Bearing Race
I have been reading some of the older posts and noticed talk about using loctite to hold the race alignment pin from falling into the ball drive.
I just buttoned up my SN-89 and did not think twice about the pin.
What type of loctite and how much do you need to use ?
-
SCH Moderator "SN Guru"
I always used red since you can use heat if you ever needed to remove it.
-
Senior SCH Member
me too, I always use the red loctite on my pins in the races.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks