SN92 Strip Down Inspection.

**Blown V8 Capri** · 02-17-2010, 11:31 AM

cheers every one for your help,
I did contact Cundn Michael. and they were very helpful, but after shipping to the uk etc it worked out over £50 UKP,
So im going to get it priced up getting one made here, to see if it works out cheaper etc,

Also im going to have to get a charger pulley made as going to use the O/E serp layout on the car but with a longer belt to drive the charger,
basicly i need the dims for the pulley shaft? overal length, how far the pulley sits from charger (back spacing) etc, reason being at a later date if we decided to change the pulley. an off the shefl one would fit and line up as it did with the custom made one,

Thanks again, this Britt would be lost without this forum,

**MAGNUMPOWER** · 02-17-2010, 12:39 PM

Hi there Capri give me a call as I can give you a contact of someone that could make both the dipstick and pully and most importanly cheaply :)

Mark 07773769478

**JPJP** · 02-17-2010, 01:02 PM

Don't forget to check Paradise Wheels for pricing as they are much less expensive than CUND. I am unsure if or what he (Paradise Wheels) charges to ship overseas.