Guys,
My car is driving me nuts. Its very rich at idle, fouling the plugs and using over 5gal of fuel just idling/revving for about 25-30 minutes! It won't rev under load. I have changed/replace the entire ignition system (everything). I would like to compare my FAST setting with what you're using. I have a base program from ASSC.
How did you set your timing? I rev the engine to 2500 and set it at the crank what the fast is showing.
What the range of your TPS? (10-93) Where is it set at idle? (24)
Closed loop parameters
closed loop high rpm- 4000
closed loop low rpm- 3900
cold closed loop delay (s) 10
hot closed loop delay (s) 10
closed loop gain (%) 30
max closed loop step (%) 9
closed loop min temp (%) 121.20
My a/f ratio is set at 13.8 at idle but actual was 9.xx!
My fuel calculation parameters are all correct. Thanks!
MIKE
Bookmarks