I am getting ready to assemble mt engine in the next few days. Are there any special precautions that i should take? I have heard of several different methods to ensure head gasket seal. Any tips will be appreciated. thanks, KEN
I am getting ready to assemble mt engine in the next few days. Are there any special precautions that i should take? I have heard of several different methods to ensure head gasket seal. Any tips will be appreciated. thanks, KEN
I can't hear you scream over my D1SC!!!!!!!!!
PICS COMING SOON!!!!!!!!!!
DSS super pro bullet 308
D1SC pullied for 14# Intercooled
80 mm Univer
75mm Edelbrock T/B
Trick Flow Track Heat Upper/Lower
Twisted Wedge heads
42# injectors/ no fmu/ PMS
MSD Digital 6
Flowtech Inductions- Ed Curtis Custom Cam
ProMotion TKO and beyond.
Steeda upper/lower control arms and anti roll bar
Bullet Racing 6 pt Chrome moly roll cage
Eaton Race Diff with 31 spline Moser Axles
I guess there are alot of "precautions" you should take before final assembly. I would prefer to call them neccesities. First making absolutely sure your deck surface and heads are perfectly flat. That is a must. New block or seasoned, doesn't matter, get it decked. Then, of course, cleaning everything... and cleaning it again. Sterile is the key word here. Then closely checking clearances. And finally torqing everything down in the correct sequence. After initial break-in period, let motor cool down and retorque heads unless your gasket intructions specifically tell you not to do so...
Bookmarks