Was planning on the MM 6pt. Can I get something else that is 4 pt, and still be good if the car breaks 11.99? Any other brands or suggestions on cages would be appriciated. Thanks -Rob
Was planning on the MM 6pt. Can I get something else that is 4 pt, and still be good if the car breaks 11.99? Any other brands or suggestions on cages would be appriciated. Thanks -Rob
No you need a minimum of 5pt (preferably 6pt) roll bar to run 11s. I would just check locally to see if there are any chassis shops that can build you a 6pt that will fit better around "you", so that the door bar passes between your should and elbow so that you pass tech. If going with a bolt-in, I would only go with one kit...a kit from Wolfe Racecraft roll bar. I've put in their 6pt kit in 3 cars and the fit was absolutely PERFECT, I was very suprised. The kit costs a tad more than other but well worth it.
Troy
1995 Mustang Cobra
302-10.77 @ 127.76
new motor being built
redsnk@yahoo.com
owner/moderator
http://www.stangtuning.com
Thanks Troy, is there a link for that? And what is the cost?
1995 Mustang Cobra
302-10.77 @ 127.76
new motor being built
redsnk@yahoo.com
owner/moderator
http://www.stangtuning.com
Thanks, did you by chance see my other post, I actually was waiting to see what you had to say about it.
No but I will check it out.
Troy
1995 Mustang Cobra
302-10.77 @ 127.76
new motor being built
redsnk@yahoo.com
owner/moderator
http://www.stangtuning.com
NHRA rules: Roll bar mandatory in all cars running 11.00-11.99. Materials must be 1 3/4" ODx 118" mild steel or .083" 4130 chrome moly tubing. This also needs to be 6pt-8pt which is better especially for 11.99 or faster.
You Must Be Fast, Cause You Were Flyin When I Passed You!
Bookmarks