I was just wondering do they sell a screw on breather that screws into the origonal oil fill cap? All I can find are rubber pop in breathers.
Most of you have breathers so please shed some light on what you use..
Thanks
Mark
I was just wondering do they sell a screw on breather that screws into the origonal oil fill cap? All I can find are rubber pop in breathers.
Most of you have breathers so please shed some light on what you use..
Thanks
Mark
ford motorsport and KN both sell the screw in breathers. Call any reputable parts shop and they can hook you up. Summit or Jegs would have them I am sure.
Neil
Engine: DSS Pro Bullet 306, Windsor Jr. heads, E303, 42lb inj., Cobra intake(fully ported lower)65mm TB, 80mm Mass Air, MSD 6BTM, MSD coil
Power Adder: Novi 1K, Anderson PowerPipe, ASP 8 IN Crank. No PS, AC, SMOG.
HP: 488.3
TQ: 461.7 Tuned by FordChip.com
11.77 @ 119.9
Best 60ft-1.56
New project 1991 coupe
NEW TOY 1995 H/D Sportster
The Ford Motorsport one is regarded as the best as I've read many times on the Corral that the K&N shrinks over time and no longer fits tight after awhile.
The part # for the Motorsprt piece is :
M-6766-N303
Last I checked it's like $20 or a little less.
the KN fits loose from the start, screws in but won't bottom out without spinning freely again. you can get it "semi" tight. you know what it's like having a "semi?" LOL!!!
Neil
Engine: DSS Pro Bullet 306, Windsor Jr. heads, E303, 42lb inj., Cobra intake(fully ported lower)65mm TB, 80mm Mass Air, MSD 6BTM, MSD coil
Power Adder: Novi 1K, Anderson PowerPipe, ASP 8 IN Crank. No PS, AC, SMOG.
HP: 488.3
TQ: 461.7 Tuned by FordChip.com
11.77 @ 119.9
Best 60ft-1.56
New project 1991 coupe
NEW TOY 1995 H/D Sportster
Bookmarks