how long did it take to install novi 1k?

**468LC** · 12-09-2002, 09:55 PM

Originally posted by KoolRockSteady
OK. I'm confused. Can I run the blower with just alt,water pump and crank?? That's all I have on the car

Yes it can be done no problem.
Chris was asking above if he needed the pulley under the blower pulley. See my pic above.

That idler pulley directly under the blower pulley is there for proper belt rap and belt traction. That same pic also shows no smog pump.:D

**lx-convertible** · 12-09-2002, 11:34 PM

took me two days working about 3hrs each day. this was with no prior supercharger installation experience. made my own discharge(thanks for great idea steve) bypassed smog, and power steering. still needs a good tune to be right, but it's getting there. fordchip did my chip by mail but it's way too conservative, only 18 degrees total timing. i run 110 octane, so it should go to 24-26 degrees and rip well into the 11's when done, maybe a high 10. not bad for a vert!

**wldtang** · 01-04-2003, 07:14 PM

OK. My car has no smog pump but has A/C and Powersteering. If I install a Novi 1000 on my car will I have to buy a smog pump delete? or will the Novi kit come with a pulley as shown in 468LC's pic?

**468LC** · 01-04-2003, 07:43 PM

You do not need a smog pump delete kit. All you need is a short piece of 1" angle iron and an alternator spacer tube to go where the smog pump would have.
Every pulley in that pic you can see comes in the kit.
The pulley right below supercharger comes with the kit and is needed for proper belt rap.

Hope this helps.