can i run with no FMU w/ 30lbs injector? or what size injectors do i need to have to run with no FMU?
can i run with no FMU w/ 30lbs injector? or what size injectors do i need to have to run with no FMU?
check out my website :www.StreetFighterRacing.cc]www.StreetFighterRacing.cc[/URL]
76 C+L, 70mm tb, Trick Flow Track Heat extrude honed, Aluminum Canfield CNC Stage II, 30lbs. injector, 1.6 RR, 306 Ci. Steeda 18# cam.
depends on boost & hp...as long as it does'nt detonate u prob w/b ok...
8lbs @6100 rpms
30's are way too small to run without an FMU imo. I wouldn't attempt it with anything lower then 42's, maybe 36's with only 8 psi. There is only one way to know for sure...that is the dyno.
Eric
1990 Mustang GT
9.20 @151.18
Check out this forum for AOD's/C4's: Click Click Racing Forums
My Homepage
I fully agree with Rdrunnr. Do not take chances with injectors that you know are too small. Oh yeah, on the dyno tip, you can do just as much damage on a dyno, blown head gaskets and worse happen all too often.
393 stroker with YS-trim Vortech :-)
sweet thanks every1 i wont try it. thanks again
Agreed, but a competent dyno operator/tuner should be watching the a/f ratio during the pull and would abort the run as the car was moving towards going lean rather then when it actually went lean so stuff like that wouldn't happen. Unfortunatley this is not always the case and bad things happen. It is important to find someone with a good reputation who knows what they are doing.Originally posted by Brcuda
Oh yeah, on the dyno tip, you can do just as much damage on a dyno, blown head gaskets and worse happen all too often.
Eric
1990 Mustang GT
9.20 @151.18
Check out this forum for AOD's/C4's: Click Click Racing Forums
My Homepage
DITTO.Originally posted by RdRunnr
Agreed, but a competent dyno operator/tuner should be watching the a/f ratio during the pull and would abort the run as the car was moving towards going lean rather then when it actually went lean so stuff like that wouldn't happen. Unfortunatley this is not always the case and bad things happen. It is important to find someone with a good reputation who knows what they are doing.
393 stroker with YS-trim Vortech :-)
Bookmarks