I am in need of a 1989 oil pan....my stock oil pan will not clear my main girdle......i have a 1989 but its rusty and with my luck will start leaking soon after the engine install!!...if you have one please let me know
Mike
I am in need of a 1989 oil pan....my stock oil pan will not clear my main girdle......i have a 1989 but its rusty and with my luck will start leaking soon after the engine install!!...if you have one please let me know
Mike
I have my stock pan, my cars an 89 and its tapped, you just gotta put the Brass fitting that Paxton supplied into it. Where are you located Mikey?
Pittsburgh....great i need the return hole anyways...and i have my fitting...no rust esp on the inside...the one i have has paint flaking on the inside ??....soo i dont want it to chip off and end up in the sump...... the one i need has a flat hump...NOT VEED...can you check it let me know how much I need it ASAP!
MIke
Summit has nice aluminum pans. I am running one that I had powder coated black.. Inexpensive, but OE quality.
Mike, I have a brand new Chrome pan from Summit that I got as a gift. I will be upgrading to a 7 qt. pan. I'd take $50.00 shipped.
Here's a couple links for it.
Click on part# 123457
Dart Block 331 and No Power Adder, currently in pieces...... :weird:Originally Posted by Kato Engineering
Used to run 6.90 @ 100.4 mph in the 1/8th
Guys...I would love to buy your oil pan..BUT you must check the HUMP.....make shure its flat NOT V shaped at all...5150....check it ang get back to me
Mike
Let me compare it to my stock 92 pan. I'll let you know.
Dart Block 331 and No Power Adder, currently in pieces...... :weird:Originally Posted by Kato Engineering
Used to run 6.90 @ 100.4 mph in the 1/8th
Here's a pic of the two side by side....
Dart Block 331 and No Power Adder, currently in pieces...... :weird:Originally Posted by Kato Engineering
Used to run 6.90 @ 100.4 mph in the 1/8th
left one is 89 right 92...i need 1989
Mike
Man that is pretty...s that the one from summit?...I need the depth of the hump lay a board across it and let me know just checked mine its 3 3/8" the highest part of the hump!
thanks
Mike
Another shot
Depth- 3 5/8 center of hump
Dart Block 331 and No Power Adder, currently in pieces...... :weird:Originally Posted by Kato Engineering
Used to run 6.90 @ 100.4 mph in the 1/8th
look at your private message...ill send you my info
Mike
Bookmarks