no boost gauge or dyno:how much psi/hp am i making with this combo???

**bdhollie** · 08-19-2003, 07:26 PM

I was thinking around 10 psi and 500rwhp. any ideas??? thanks bryan

`90 LX Hatch A9L
Keith Craft 306
TFS Track Heat Heads
TFS Track heat Intake
Accel 300+ Ignition & coil
80mm Pro-M
75mm Accufab TB
55lb. injectors
Anderson B-3 Cam
3.73
4-point cage
Sub Frames
Lakewood 70/30 struts
Lakewood Drag Springs
Comp. Eng. Rear Shocks
Tremec 3550 w/ Hurst
255lph in-tank
255 in-line pump
JMS Chip
Morpheus Powerpipe
Novi 2000 (stock pulleys)

**sinner** · 08-19-2003, 07:45 PM

First off, this is the Novi 1000 section so you'd probably get some better responses in the Novi 2000 section but I'll try answering some anyways.
If you could go to the track and get some times/MPH and get your car weighed we could get you a rough HP idea.

Your probably around 500HP on a dyno jet.

I too, would guess you to be around 10lbs.

**allen** · 08-19-2003, 11:45 PM

it better mine made 564hp at 6100 rpm with a stock cam and 50lb injectors it will make more boost the higher you spin it mine made 18lbs at 6800 never got to dyno it when i spon it that high

**bdhollie** · 08-23-2003, 10:27 AM

hey allen, whats your combo???

**FoMoCo1** · 08-23-2003, 11:02 PM

see my sig
my combo is similar to yours
those numbers are with no tune
no timing, and 91 octane

**allen** · 09-01-2003, 10:06 PM

trick flow heads unported and a street heat intake unported stock cam 50lb msd injectors 75mm prom bullet 70 mm throttlebody 306ci stock procecer with 26 degrees of total timming with the spout removed and 50lbs of base fuel psi i shut the car off at 6100 on the dyno and it made 564hp and 505 ft lbs 1 5/8 shorty headers and a dr gas 2 1/2 x pipe and flowmaster mufflers and that was on a super flow dyno they will show lower hp #s than a dynojet