-
Senior SCH Member
Setting timer with Blower.
Running about 5-7lbs, what is a good timing to set it at? 13, or 9? or anything else?
-
SCH Moderator "SN Guru"
You can keep the timing at 10 degrees if you under 5psi and for every 1psi over that take out 1 additional degree. Of course the best thing would be a boost controller so you can keep your timing at 14 degrees and remove timing under boost.
-
Junior SCH Member
Is 10 degress good for 6-7psi of boost?
-
Banned by Admin
The stock computer adds 16 to your initial.
10 + 16 = 26 total. 26 total is ok for 6-7lbs of boost.
As always when you make changes be sure to listen for any detonation. Always use the best fuel you can.
Ian
-
Senior SCH Member
i jsut boguht a boost timing master, what should i set my timing at with that? its at 10deg right now and the dial is set to 1 degree
-
SCH Moderator "SN Guru"
Set you timing back to the location the car ran best before the supercharger. If it ran best at 14 degrees than make the adjustment and set you timing unit at .5 degree per pound. At six pounds you should be at about 27 degrees total timing.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks