I'm looking to get some giggle juice and was wondering what type of Nitrous system to go with. I'm looking around 50-75 hp on a KB supercharged LX. Thanks for the replies
I'm looking to get some giggle juice and was wondering what type of Nitrous system to go with. I'm looking around 50-75 hp on a KB supercharged LX. Thanks for the replies
In that HP range, you will be fine with a Dry shot,, Bee
thanks for the info bumblebee03
what would be the most nitro you could inject safely
This would depend on multiple factors.Originally Posted by mark007
What kind of bottom end one is running.
What horsepower level is prior to nitrous.
How well the car is tuned.
A fuel system that is up to par for the job.
As long as the tune is conservative, the bottom end is sound and the fuel system is up to snuff one could add enough nitrous to bring them up to the limits of the stock block. Most I've ever run across someone adding was around 100-125 shot on top of the blower.
Dart Block 331 and No Power Adder, currently in pieces...... :weird:Originally Posted by Kato Engineering
Used to run 6.90 @ 100.4 mph in the 1/8th
5150LX
Would that be a wte or dry system? N/A it made close to 325 hp with the kennebell i think it will make around 450 hp at the fly.
Thanks for the reply
If it was me, I would not chance a dry set-up. Wet is the only way I'd go, better to have too much fuel than not enough.
Dart Block 331 and No Power Adder, currently in pieces...... :weird:Originally Posted by Kato Engineering
Used to run 6.90 @ 100.4 mph in the 1/8th
Would a wet system damage the seals on the kennebell??
To be honest, I really don't know & didn't even think of that. PM Goliath, he's got some knowledge in this area.
Dart Block 331 and No Power Adder, currently in pieces...... :weird:Originally Posted by Kato Engineering
Used to run 6.90 @ 100.4 mph in the 1/8th
Would there be room for a plate setup between the blower and the intake?
89 Coupe with parts stacked inside of it and about 30#'s of dust on it with no end in sight. :weird:
Although I am collecting parts for a 12.5:1 393 :D
Yes there would be room to put a plate system, but isn't that a little to RAD. The lowest shot that I've seen is 150hp. Remember stock bottom end with a main support and stock rods on forged pistons.
HA go big or go home!
yeah that makes sense....it would make TQ like a 514 though!
89 Coupe with parts stacked inside of it and about 30#'s of dust on it with no end in sight. :weird:
Although I am collecting parts for a 12.5:1 393 :D
how about a fooger by all means, what do you think regattacoupe; Sounds like a plan?
Hmm could you ween a fogger down where you want it to be?
89 Coupe with parts stacked inside of it and about 30#'s of dust on it with no end in sight. :weird:
Although I am collecting parts for a 12.5:1 393 :D
.........But of course, anything is possible, eh!
Bookmarks