i just bought a TKO off of ebay and need to get a bellhousing, slipyoke, and clutch disk for it. anyone know where would be the best place to buy this stuff from?
i just bought a TKO off of ebay and need to get a bellhousing, slipyoke, and clutch disk for it. anyone know where would be the best place to buy this stuff from?
92 LX 5.0- 12.55@115.33
409rwhp and 372rwtrq
www.geocities.com/slider_buck
http://www.cardomain.com/memberpage/322771
Eric
1990 Mustang GT
9.20 @151.18
Check out this forum for AOD's/C4's: Click Click Racing Forums
My Homepage
i'll have to give them a call in the morning. there website must be messed up right now because you can't bring up there catalog.
92 LX 5.0- 12.55@115.33
409rwhp and 372rwtrq
www.geocities.com/slider_buck
http://www.cardomain.com/memberpage/322771
well i called hanlonmotorsports and she said that they are out of stock on them. she also said that they probably won't be getting anymore of them because of the new tko's that are coming out. i'm going to try and call brothers and see if they have any in stock. the guy that i bought the tko from had a yaok so i bought it from him. now all i need is the bellhousing and disk.
92 LX 5.0- 12.55@115.33
409rwhp and 372rwtrq
www.geocities.com/slider_buck
http://www.cardomain.com/memberpage/322771
Try JD's, they hooked me up with a killer price on my PA C-4 Bell ($75 less than anyone else) Just drop them any e-mail and let him know you were referred by SCH
Dart Block 331 and No Power Adder, currently in pieces...... :weird:Originally Posted by Kato Engineering
Used to run 6.90 @ 100.4 mph in the 1/8th
who is jd?
92 LX 5.0- 12.55@115.33
409rwhp and 372rwtrq
www.geocities.com/slider_buck
http://www.cardomain.com/memberpage/322771
www.jdsperformance.com
They are excellent too.
Eric
1990 Mustang GT
9.20 @151.18
Check out this forum for AOD's/C4's: Click Click Racing Forums
My Homepage
Make sure you get the McCleod bellhousing and extended shift fork. I installed one of these with my TKO, and the only modification I had to do was the opening for the starter. I did not have to shim/measure/adjust anything for the transmission to line up.
Bookmarks