I'm having the same problem Pny Pwr did, as well as "5.0" magazine, with the inlet tube not matching up with the TB. What is the deal with this!? I have not tried "clocking" the blower yet so I am hoping that will fix it or at least make it better but it doesnt look like it will, its pretty far off.
It just pisses me off that I have to hack a brand new cast aluminum piece from the kit all up! Has anyone run into problems with blowing the inlet tube off or seaping air after cutting the inlet tube b/c it has those raised sealing rings at both ends of the pipe. I'm wondering if I should call Paxton first and just make sure they know that if I cut this thing up and then it leaks that I plan on shipping it back to them.
Other than this the install has gone pretty well. The tensioner running into the water pump pulley sucks too but from what I have read it is "normal" with the kit and doesnt seem ot be a way to fix it. I cant wait to get this beast running!!! :)
Bookmarks