Just wondering what the average person sees with the installed pulley?
Just wondering what the average person sees with the installed pulley?
Avg I see is 16-20. Depending on cubes. I guess I should note around 6,000 rpm'sOriginally Posted by mechfan81
Last edited by BLOWNBY; 03-24-2005 at 10:42 AM.
351 "stockshort block": -Vortech T-trim (21 psi), Trick Flow Heads, Lunati Cam, Weldon fuel system, Lentech AOD., 3.55 gears, 27" Hoosier QTP's, 3500# with me
-545 rwhp
-10.02 @ 135mph---Is 9.99 to much to ask?:freaks:
-1.42-- 60'
Originally Posted by regattacoupe
With a YSi and a 3" upper, 8" lower, I seen 24lbs at 7000rpm. Holley intake, 306, Ren cam, 310 ci . Switched to a 2.85 and the boost went to 28.5lbs. In our renegade car we ran the 2.75, but we had bigger heads.
With the YS, with the 3" I made 21lbs and with the 2.85 I made 24lbs.
10.13 out of a S trim
680 hp out of a YS trim
8" lower, 3.3" upper just a guess. The key here is belt wrap. The internals are large and heavy, inertia can cause belt slippage. Thats what I would try if it were me and I wanted around 12lbs out of a YS.
10.13 out of a S trim
680 hp out of a YS trim
Prbably and 8" & 3.33"Originally Posted by mechfan81
351 "stockshort block": -Vortech T-trim (21 psi), Trick Flow Heads, Lunati Cam, Weldon fuel system, Lentech AOD., 3.55 gears, 27" Hoosier QTP's, 3500# with me
-545 rwhp
-10.02 @ 135mph---Is 9.99 to much to ask?:freaks:
-1.42-- 60'
Originally Posted by regattacoupe
That is a lot of charger for just 12 lb.?? You plan on building a better combo later?
Let's Roll....
oh yeah, definitely. i know what speed and power i want, so i dont think a smaller blower could pull it off. i intend to use 25lbs by september.
With the stock 8" / 3.33" pullies my 20 pound boost gauge was pegged almost instantly..
Eric
1990 Mustang GT
9.20 @151.18
Check out this forum for AOD's/C4's: Click Click Racing Forums
My Homepage
I thought you were running the 8"/3" not the 3.33. Hmmm.Originally Posted by RdRunnr
351 "stockshort block": -Vortech T-trim (21 psi), Trick Flow Heads, Lunati Cam, Weldon fuel system, Lentech AOD., 3.55 gears, 27" Hoosier QTP's, 3500# with me
-545 rwhp
-10.02 @ 135mph---Is 9.99 to much to ask?:freaks:
-1.42-- 60'
Originally Posted by regattacoupe
My bad....I am running the 8"/3" combo..
Eric
1990 Mustang GT
9.20 @151.18
Check out this forum for AOD's/C4's: Click Click Racing Forums
My Homepage
Bookmarks