Did you extend the wires that go to the coil?
Any issues doing this?
Also I have a three step and the wire to plug into the MSD rev limiter is only like 5". Can I extend this to put the three step in a convenient spot??
Also if you have a BTM with the MSD in the car where did you mount the BTM. Inside or out?
Thanks
Last edited by BLOWNBY; 05-01-2005 at 02:12 PM.
351 "stockshort block": -Vortech T-trim (21 psi), Trick Flow Heads, Lunati Cam, Weldon fuel system, Lentech AOD., 3.55 gears, 27" Hoosier QTP's, 3500# with me
-545 rwhp
-10.02 @ 135mph---Is 9.99 to much to ask?:freaks:
-1.42-- 60'
Originally Posted by regattacoupe
i have almost all my wire extended with a AL7.solder them if you are worried at the connectors.
"69"Satellite,440,8-71,996hp at 6K/983TQ at 4K,4000lbs.
I have both my 6AL and vortech BTM in the car (under the seat). I extended the wires from the coil with a heavier gauge wire to and from. If you have a boost gauge you can T into its line for the BTM inside the car. Works great!
Jason
92 Notch w/ S-trim (6.87/2.95), 04 PMS, UPR pipe, WMS w/b, GT-40Y heads, Cobra manifold, B303, 1.6 stud r/r, 65mm TB, 80mm Pro-M, 42# injectors, FRPP balancer, FRPP aluminum rad, FRPP blue hose kit, Ramcharger fan, Edelbrock w/p, Canton 7qt pan, MAC 1 5/8" shorties, MAC catted H-pipe, Flowmaster cat back, MAC springs, Tokico HPs, MM c/c plates, Steeda X2s, MM adj. rears, Cobra brakes, 17" Cobra R's, 3.55 gears, aluminum d/s, Hurst, Cobra clutch, Kenny Brown subs + K-brace, Ultra-lites, MSD 6AL, GSS340-255lph intank.
That was prettyt much what I planned on except with my stuff mounted under the dash. Since I currently have it out anywys.
Thanks
351 "stockshort block": -Vortech T-trim (21 psi), Trick Flow Heads, Lunati Cam, Weldon fuel system, Lentech AOD., 3.55 gears, 27" Hoosier QTP's, 3500# with me
-545 rwhp
-10.02 @ 135mph---Is 9.99 to much to ask?:freaks:
-1.42-- 60'
Posting Permissions
Reply With Quote
Bookmarks