SCH idler pully spacers?

**BOSS LX363** · 01-02-2006, 09:58 PM

I have the SCH brackets and cannot figure out how, and what spacers to use.

I am using the 35mm cog kit.

I will post a pic....

**BOSS LX363** · 01-02-2006, 10:11 PM

pic with all the spacers that I have...

**BOSS LX363** · 01-03-2006, 11:51 AM

ttt

**Chuck** · 01-03-2006, 03:42 PM

I need a better pic than that if possible. I have the bracket aswell so I can take pics of what you want to see.

**root** · 01-03-2006, 04:59 PM

The one on the right.

Install everything and make sure it all lines up.

Ian

**BOSS LX363** · 01-03-2006, 05:41 PM

Ian, with that spacer there is about a 1/2 inch of play?

2 more pics

**root** · 01-03-2006, 05:49 PM

If the spacer comes flush with the edge of the pulley its the one.

Ian

**BOSS LX363** · 01-03-2006, 05:54 PM

It comes past the edge about a 1/4 inch.

**root** · 01-03-2006, 05:57 PM

Then that is not the one.

Ian

**BOSS LX363** · 01-03-2006, 05:59 PM

Ian, can I just cut the extra off?

If not can I buy the right one from you?

**root** · 01-03-2006, 06:01 PM

Cannot simply cut as the spacing off the front plate will not be correct.

Did you buy the kit direct from me?

Ian

**BOSS LX363** · 01-03-2006, 06:03 PM

I bought the kit used, but it was never on a car.

I will pay for a new spacer.

**root** · 01-03-2006, 06:05 PM

I think all my stock is gone, I will have a look.

Ian

**BOSS LX363** · 01-03-2006, 06:07 PM

Thanks for any help!

If you don't have any, do you have the exact dimensions?

**BOSS LX363** · 01-07-2006, 09:25 PM

Any luck Ian?

Thread: SCH idler pully spacers?