I finally got my vr4 intalled on my mustang, And am getting dyno tuned in about 2 weeks, after i get my new intake and injectors. Kinda wondering if i'm going to hit the 500rwhp mark. Any imput is good, let me know what you think.
It was dynoed on a mustang dyno and made 329rwhp (@4300rpm, i think the intake and heads were the problem with the low peak rpm) and 395ftlb. Ordered a trick flow r-series intake, to replace the gt40 it was dynoed with
-combo-
-408 stroker
-windsor jr heads
-trickflow r-intake, 75mm throttle body, 85mm mass air, 55lb injectors
-custom ground blower cam (comp cams) not sure of the specs, i've got to get them from my engine builder
-vr4, 4inch powerpipe, 3.75 blower pully, and stock sn2000 crank pully (not sure what boost #s it going to make)
-all msd componets, full exhaust
-5 speed
Bookmarks