-
Junior SCH Member
8-Rib Pulley Setup
Does anyone know if the Novi or Vortech pulleys will fit the SN input shaft?
Thanks.
-
Junior SCH Member
Apparently photobucket got the message and is no longer charging to have images hosted on websites. So this site got back a lot of missing pictures.
This post shows an SN with a procharger pulley.
http://www.superchargerhelp.com/show...ll=1#post64760
-
Junior SCH Member
I bought a vortech pulley and it was quite a bit different. Obviously the offset was different, and the ID of the pulley was 20mm or something instead of the .875" that the SN uses. I had to bore the pulley out and make a custom key, but I'm up and running.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks