hello, I was just looking though all the good info here and noticed all the mounts for ford 302s and 351s are different then what I have. Is mine a custom 1 off or is it from an old design? any and all help would be appreciated.
I'm only familiar with the foxbody brackets that came in the kits. Which means I know just enough to be dangerous.
That bracket for the alternator looks entirely different then what I have. Whats the spring for near that tensioner pulley?
Over the years I've seen quite a few custom made brackets on the internet. Thats probably what you have but again, I'm not that familiar with the brackets. What block is that on?
Though I'm almost certain it's not this but I work at a restoration shop. We have an old Avanti that came from the factory with a Paxton SN60. The brackets look similar but it's hard to see because engine is still in it.
Is that spring tensioner for the serpentine belt & not the belt for the charger? I ask because I dont think a spring loaded tensioner is enough for the charger belt. The paxton one is locked into place by two bolts & the belt will still get loose at times.
If you haven't looked a few posts below is the install manual for an SN89 or 92. it should have good pictures of the bracket.
Posting Permissions
Reply With Quote
Bookmarks